Product Details

XK RC Helicopter

XK K110S 6CH Brushless 3D6G System RC Helicopter BNF Mode 2 Compatible With FUTABA S-FHSS

Last updated: 08 February 2024
4,49 55 reviews
🛒 83,37$ from Banggood 🛒
Battery Quantity: with 1 Battery
Ship From: CN
6.606 Heats
175 Wishlist
Share on:
Questions and Answers
Q

Aside from the canopy, what is the difference between this and the XK K110?

by BG504734131, on 29 November 2021
A

No difference and its more expensive than the 110 with four batteries

by BG483216555, on 23 December 2021
Q

What's the difference from hk k110? Canopy color? What is the difference from xk k110? Canopy color?

by naZaar, on 24 November 2021
A

Upgraded the servo and canopy

by ShihTzu, on 01 December 2021
Reviews
5 out of 5 stars
BG111151454 on 16 December 2023

Item in order. all ok.

5 out of 5 stars
BG451235169 on 07 December 2023

It was my second purchase, but I was about 10 days late to ship. Because it's a popular product? The product was very good, but unfortunately.

5 out of 5 stars
BaneiOgawa on 06 December 2023

Very great‼︎

5 out of 5 stars
Edbrooke on 07 October 2023

Super helicopter. You will not be disappointed. Excellent packaging.

5 out of 5 stars
BanglaBaagh on 26 September 2023

Package came early as always… thank you Banggood! Yet to take it for a run. This whole binding with a smart remote takes a minute to figure out. Stay tuned for a flight review

5 out of 5 stars
Ali123 on 27 August 2023

I bought Walkera v120d02s over 10 years ago and if I compare their crash resistance, Walkera was made from egg shells and XK from titanium. It had a lot of vibrations out of the box but after tightening all the screws, especially between the blade clips, vibrations are now minimal. The swash plate is the same as on Walkera, so I put a metal one on, even though the plastic one was just fine. After 10+ crashes, I only managed to break the rear canopy pins, so I tied a plastic band to prevent the canopy from vibrating. When I was looking at the tail motor, I pulled it out just a little, and I broke one of the thin wires, so I soldiered some thicker ones and taped them under the tail rod with some light wind tape. The tail prop can easily become loose, so I put a drop of CA glue on it to hold it tight. I use Gaoneng 520mah lihv. It can bind with Jumper t8sg.

5 out of 5 stars
starflight10@gmail.com on 21 August 2023

I've already flown quite a few helis. This one is the best I've come across. Fully recommended.

5 out of 5 stars
BG193785116 on 06 July 2023

as described, nice and fast! Announced earlier than expected arrived. Well packaged. Documentation detailed during the process. :)

5 out of 5 stars
BG143543451 on 30 June 2023

Good product quality, terrible sales service

5 out of 5 stars
BG381956323 on 28 July 2022

perfectly bind & fly with TX16S using EdgeTX