RC Airplane
Freewing 1026mm Wingspan EPO Delta Wing FPV Flywing RC Airplane KIT
Questions and Answers
what is the cg of this plane?The manual did not mention at all.
On the wings below the notch. You pick up within them. I've got the best version of 190mm from my nose.
what is the cg of this plane?The manual did not mention at all.
There should be marks on the bottom side of the wing. See red arrows in the lowest image below the description.
Reviews
ЭрнстНеизвестный on 25 January 2020
The package is disgusting, the plane broke down in several places. I'm not gonna order any more, I'm not sure it's coming in one piece.
andy on 05 October 2019
Great cheep delta wing, steady as a rock, have ordered another, good value..
amirmz on 07 June 2019
very good, all in shape.
kbraurc on 01 May 2019
excelente
apollo7 on 09 March 2019
Nice flying wing but be warned, if you have to open a paypal claim do not close it again as they will take your money and just fob you of with excuses
FahriB on 19 February 2019
Great value!
katvov on 10 February 2019
все пришло очень быстро , но упаковка не очень хорошая и товар незначительно пострадал . упаковку нужно делать лутше.
Dom on 11 August 2018
Assembled easily. Written instruction in Chinese only. Mounted a Race star 1800kv motor with a 7/5 prop. I live & fly at 7630 ft ( 2326 M ) above sea level. Thin air requires more prop. Climbs at a brisk rate with 60% throttle. Stated CG would not allow stable flight with motor off. Moved CG to 7 3/4" ( 194mm ) back from the tip of the nose. Now dead steady with motor off. A real floater. With a Turnigy 3 cell 2200ma 20C lipo I easily get 18 min flights between motor & gliding. I made finger hole on either side of the center keel so as to better grip for launch. Toss up & straight into the wind & the wing climbs straight as an arrow .& up. I suggest a little up trim which really helps the launch. . I fly on low rates with 50% throw. Very stable. On high rates at 100% throw very aerobatic. Notice rubber band hold down for hatch. Do not trust magnets only!!! Installed a wood motor mount as to be able to easily change motor. Covered complete wing with 2" nylon strapping tape. Makes your wing super tough. Well worth the time. I enjoy this wing & would buy again..
RagTheNutsOff on 14 May 2018
Upon opening the box, I knew exactly what I was going to it. Glued up in a few minutes and I also laminated mine. Set up with a BR2212 1000Kv motor with a 7x5 prop, then a flight stabilizer (was inav, now a vector), added FPV gear and made a 4S li-on battery pack. Flies very well, although not tested at any speed! One negative point is that this model is quite low density EPO foam. Would have loved to see it in EPP. Oh and there were no magnets in the box to hold the lid down, so used a servo control horn as shown in the photos. And the BG pictures show landing gear, again not in the box.
Rastas97 on 04 May 2018
contenu assez complet mais il manque des protections sur le carton d'emballage quelques morceaux abîmée