FlySky Radios & Receiver
FlySky FS-iA6 2.4G 6CH AFHDS 2A Receiver For FS-i10 FS-i6 Transmitter
Questions and Answers
Will this work with RadioMaster TX16S using AFHDS 2A? Will it work with std. servos?
yes. I use them with my Radiomaster TX16. works flawlessly. great little light weight Rx.
sir i have already old fs i6 tx, but i lost my fs ia6 Rx, so i want to but this new fs iA6 Rx. so this will work with my old Tx or not?
Yes this will work the same as your original Rx. However be aware that unlike the FS-iA6B Rx this one does NOT allow connection of sensors nor does it support I-BUS. I have a few of each of these receivers and use depends on the space available and importance of saving a few grams. Hope this helps.
Reviews
BG191648244 on 20 May 2024
With the product itself satisfaction. Unfortunately, out of the ordered 2 pieces, one arrived damaged by transport (bent connector). A complaint was necessary. However, the seller quickly acted and corrected the mistake by sending a new 1 piece without requesting additional payment. I was looking forward to receiving the new receiver. It arrived relatively quickly, I was very happy. To my unpleasant surprise, the product suffered damage during transport again :-(. That already saddened me, such a sensitive product requires better packaging, at least bubble wrap or cardboard. I have written 2 complaints again, so now I am waiting. Thank you.
FelixPfx on 14 October 2022
Works great on my Viper!
niczo on 30 July 2022
I received the customer in perfect condition. It's not built in yet, I hope it works well.
BG224817575 on 19 October 2021
Very used for our gliders and planes with very good range and good response to the Flysky i6 Control. Reviews and flights on YouTube Channel "DMC Tec"
Michael Arden-sonego on 23 June 2021
looking good. haven’t tried it yet but I usually have success with these . very fast service :)
Jesus on 17 February 2021
Good afternoon. I received the order, but due to the poor packaging the connectors are completely bent, I hope they will give me a suitable solution . Thank you
Ninou33540 on 27 July 2019
recepteur flysky un peut plus petit que le fsia6b mais avec le sbus et l'entrée capteur en moins
JoaoMAP on 21 May 2019
Ainda não testei, mas é lindo e bastante leve!
Abner on 01 July 2017
produto muito bom e de ótima qualidade entrega muito rapida
Marco on 27 July 2016
Perfect if you don't need PPM. It is much lighter than the FS-iA6B. To bind, plug the bind plug in the B/VCC port. Power on the Rx. Press and hold the bind button on the Tx and turn on the Tx. Wait a couple of seconds then release the bind button. Remove bind plug and then remove power from Rx.